Before you start
- A mesh Wi-Fi kit
- The maker’s app on your phone
Method 1 Set up the main unit
-
Step 1: Connect it
Plug the main mesh unit into your modem/fibre box (or your provider’s router) with the supplied Ethernet cable.
-
Step 2: Use the app
Install the maker’s app (TP-Link Deco, Google Home, eero, Netgear Orbi, ASUS ZenWiFi) and follow the setup steps.
-
Step 3: Choose your Wi-Fi name
Use your old network name and password to reconnect existing devices automatically.
Method 2 Place the extra units
-
Step 1: Halfway rule
Put each satellite about halfway between the main unit and the area with poor coverage, not inside the dead zone.
-
Step 2: In the open
Off the floor, away from TVs, metal and thick walls, ideally with a clear line of sight to the main unit.
-
Step 3: Check the app
The app shows connection quality for each unit. Move it closer if it says “weak” or “poor”.
Method 3 Get the best performance
-
Step 1: Wired backhaul
If your home has Ethernet sockets, connect the units with cables. This frees all Wi-Fi bandwidth for your devices.
-
Step 2: Avoid double NAT
If you keep your provider’s router, put the mesh in Access Point mode, or put the provider router in bridge/modem mode. Two routers both handing out addresses can cause gaming and smart-home issues.
-
Step 3: Turn off old Wi-Fi
Disable Wi-Fi on the provider’s router to avoid interference and confusion.
Troubleshooting
A satellite won’t connect
Move it closer to the main unit, reset it (hold reset until the light changes), and add it again in the app.
Devices stick to a far unit
Turn Wi-Fi off and on on the device, or reboot the system; most mesh systems steer clients automatically.
Frequently asked questions
Mesh or extender?
Mesh gives seamless roaming and better speeds across a large home. Extenders suit a single weak room on a budget.
Can I mix brands?
Generally no, except EasyMesh-certified devices.
Summary
Connect the main unit to your modem, set it up in the app, place satellites halfway to weak areas, and use Ethernet backhaul if possible. Avoid double NAT with AP or bridge mode.
